Asmodus x Ultroner - Luna Squonk 80W
Allow us to present the Luna Squonk box mod, a collaborative effort between with Ultroner and asMODus. The Asmodus Luna is constructed from 6063 aluminum alloy and then covered in stabilized wood. The Ultroner Luna is a single-battery, unregulated Squonk mod that packs a punch while boasting an aesthetically pleasing design.
asMODus is laser engraved into the firing button which has as responsive, click button. The Luna is unregulated, so you cannot control the output power (meaning you cannot set a wattage) and it will use the full power of the battery up to a maximum of 80.0w watts until the battery drops too low to use. While being unregulated the mod offers multiple built in safety features as well as an LED indicator light to keep you updated with just a glance.
The Ultroner x Asmodus Luna Squonker Box mod is easily turned on and off; simply click the fire button 5 times and the LED will flash blue. The Luna has a protection chip inside that guards the user from a wide variety of potentially volatile safety issues. The following protections have been enabled by use of this chip:
Reverse polarity: The LED indicator will flash green when a battery is properly installed will not flash if the battery is installed incorrectly.
Low Voltage Protection: When the battery voltage hits 3.3 volts the LED will flash red five times and the mod will shut off, protecting the mod, battery, and most importantly, the user.
Cut Off Timer: The mod will automatically shut off if attempting to fire the mod for over 10 seconds. In case of any auto or accidental firing, this mod is prepared.
Atomizer Short Detection: The LED will flash red is the Luna detects a short in the user's atomizer.
Overheating prevention: If the Luna reaches an internal temperature of over 85°C / 185°F, the mod will automatically turn off.
The squonk bottle positioning was made specifically to be easy to fill. There is a sliding, magnetic cap located on the bottom of the device to provide easy access to the squonk bottle. By simply sliding out the cap, the bottle can be removed by pulling it downward. The bottle has a needle nosed tube at the end that serves as both as the juice reserves and the means of injection into your bottom feeding atomizer.
To open the bottle, you unscrew the top cap and fill juice (with a maximum capacity of 7.0mL) and then screw the top back on once it's full. When you are done you can push the bottle back through the magnetic sliding cap door with the needle nose tube going around the needle hanging down from the 510 pin.
- Dimensions: 82mm x 46mm x 26mm
- Powered by a single 18650 sized battery (not included)
- Constructed from 6063 aluminium and then encased in stabilized wood
- Unregulated mod with a powerful protection chip, the UL-80-JX
- LED indicator light which will helps to keep you notified of the status of the Luna
- Atomizer resistance range: 0.1 - 3.0 ohm
- Maximum output power: 80.0 watts
- Output voltage range: 3.3 - 4.2 volts
- Maximum output current: 27 amps
- 1x Luna Bottom Feeding Protected Box Mod by Ultroner and asMODus
- 1x Luna Squonk bottle (pre-installed)
- 1x Luna Sqounk bottle (spare)
COLOURS AND PATTERN SHOWN WILL VARY TO THE ACTUAL UNIT DUE TO THE NATURE OF WOODS AND STAINS APPLIED TO WOOD, THESE ARE JUST EXAMPLES.